Rohde & Schwarz R&S SMB100B - LF Signal Output Settings

Analog modulations
R&S
®
SMB100B
105User Manual 1178.3711.02 ─ 08
Settings
Distribution.................................................................................................................. 105
Bandwidth................................................................................................................... 105
Distribution
Selects the distribution of the noise power density.
"Gauss"
Generates the noise power according to a Gaussian distribution.
"Equal"
Generates an evenly distributed noise.
Remote command:
[:SOURce<hw>]:NOISe:DISTribution on page 488
Bandwidth
Sets the noise bandwidth as distinct value.
You can set the bandwidth between 100 kHz and 10 MHz in 100 KHz steps.
Remote command:
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth on page 488
[:SOURce<hw>]:NOISe:BWIDth:STATe on page 488
5.4.8 LF signal output settings
Access:
► Select "Modulation" > "LF Output".
Modulation settings