Rohde & Schwarz R&S SMB100B - HUMS Remote Control Commands

Remote control commands
R&S
®
SMB100B
374User Manual 1178.3711.02 ─ 08
:DIAGnostic<hw>:POINt:CATalog?
Queries the test points available in the instrument.
For more information, see R&S SMB100B Service Manual.
Return values:
<Catalog> string
List of comma-separated values, each representing a test point
Example: See Example"Programming example" on page 372.
Usage: Query only
:DIAGnostic<hw>[:MEASure]:POINt? <Name>
Triggers the voltage measurement at the specified test point and returns the measured
voltage.
For more information, see R&S SMB100B Service Manual.
Query parameters:
<Name> <test point identifier>
Test point name, as queried with the command :
DIAGnostic<hw>:POINt:CATalog?
Return values:
<Value> <value><unit>
Example: See Example"Programming example" on page 372.
Usage: Query only
12.8 HUMS remote control commands
The remote control commands for the health and utilizations monitoring system
(HUMS) comprise commands of the DIAGnostic subsystem and the commands of
the SYSTem:COMMunicate:REST and SYSTem:COMMunicate:REST subsystems.
For all HUMS-related remote control commands, see refer to the "R&S
®
HUMS Health
and Utilization Monitoring Service" User Manual on the Internet.
Commands
DIAGnostic:HUMS:DELete:ALL....................................................................................... 375
DIAGnostic:HUMS:DEVice:HISTory?................................................................................375
DIAGnostic:HUMS:DEVice:HISTory:DELete:ALL............................................................... 376
DIAGnostic:HUMS:FORMat............................................................................................ 376
DIAGnostic:HUMS:SAVE................................................................................................ 376
DIAGnostic:HUMS:STATe............................................................................................... 377
DIAGnostic:HUMS:TAGS:ALL?....................................................................................... 377
DIAGnostic:HUMS:TAGS:DELete.................................................................................... 377
HUMS remote control commands