List and sweep mode
R&S
®
SMB100B
131User Manual 1178.3711.02 ─ 08
"Step / Extern Step"
Generates the sweep signal step-by-step, manually triggered.
"Extern Start/Stop"
Generates a continuously repeating sweep signal that is started,
stopped, and restarted by subsequent external trigger events.
The sweep steps are performed automatically, controlled by the dwell
time.
Remote command:
RF frequency sweep:
[:SOURce<hw>]:SWEep[:FREQuency]:MODE on page 510
:TRIGger<hw>:FSWeep:SOURce on page 548
RF level sweep:
[:SOURce<hw>]:SWEep:POWer:MODE on page 509
:TRIGger<hw>:PSWeep:SOURce on page 548
RF combined sweep:
[:SOURce<hw>]:SWEep:COMBined:MODE on page 516
:TRIGger<hw>:FPSWeep:SOURce on page 549
LF frequency sweep:
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE on page 472
:TRIGger<hw>:LFFSweep:SOURce on page 548
Retrace
For "Shape = Sawtooth" and "Mode = Single/External Single", enables changing the
signal to the start value while it is waiting for the next trigger event. It returns to the
start level or start frequency until the next trigger is applied.
Remote command:
RF frequency sweep:
[:SOURce<hw>]:SWEep[:FREQuency]:RETRace on page 512
RF level sweep:
[:SOURce<hw>]:SWEep:POWer:RETRace on page 512
RF combined sweep:
[:SOURce<hw>]:SWEep:COMBined:RETRace on page 516
LF frequency sweep:
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace on page 472
Shape
Selects the waveform shape of the sweep signal.
Sweep mode settings
To Next Page
Loading...
