Rohde & Schwarz R&S SMB100B - Accessing the File System of the R&S SMB100 B over FTP

File and data management
R&S
®
SMB100B
217User Manual 1178.3711.02 ─ 08
2. Enable "LAN Interface"
3. Select "Samba Services".
4. Enable the "SMB 1.0/2.0 Client".
5. Enable the "SMB 1.0/2.0 Server".
6. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 10.4,
"Using the security settings", on page 248.
7. Select "Accept".
To enable file transfer over USB
1. Select "System Config > Setup > Security > Security > General"
2. Select "Disk & Memory".
3. Enable "USB Storage"
4. Enter the "Security Password".
The default password is 123456. For more information, refer to Chapter 10.4,
"Using the security settings", on page 248.
5. Select "Accept".
9.9.2 Accessing the file system of the R&S SMB100B over FTP
If the R&S SMB100B is connected to a LAN, you can use file transfer protocol (FTP) to
access the file system and to transfer files from and to the instrument.
How to: see Chapter 3.1.7, "Connecting to LAN", on page 27.
To access the file system over FTP
We assume that the instrument and the remote PC are connected to a LAN.
1. Enable file transfer via FTP
2. Enable write permission on the file system
3. On the remote PC, start the Windows Explorer.
4. In the address field, enter ftp://<"IP Address" of the Instrument>, e.g.
ftp://10.124.0.166.
Tip: The R&S SMB100B indicates its IP address on the home screen.
A log-on dialog opens and requests a password.
The default user name and password is instrument.
Tip:
Default password
The FTP and SAMBA file access use the user "instrument" with default password
"instrument".
How to transfer files from and to the instrument