Rohde & Schwarz R&S SMB100B - Noise Generator

Remote control commands
R&S
®
SMB100B
488User Manual 1178.3711.02 ─ 08
12.15.7.1 Noise generator
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth.....................................................................488
[:SOURce<hw>]:NOISe:BWIDth:STATe............................................................................488
[:SOURce<hw>]:NOISe:DISTribution............................................................................... 488
[:SOURce<hw>]:NOISe:LEVel:RELative?......................................................................... 488
[:SOURce<hw>]:NOISe:LEVel[:ABSolute]?.......................................................................489
[:SOURce<hw>]:NOISe:BANDwidth|BWIDth <BWidth>
Sets the noise level in the system bandwidth when bandwidth limitation is enabled.
Parameters:
<BWidth> float
Range: 100E3 to 10E6
Increment: 100E3
*RST: 100E3
Example: See Example"Configuring the noise generator" on page 487.
Manual operation: See "Bandwidth" on page 105
[:SOURce<hw>]:NOISe:BWIDth:STATe <State>
Activates noise bandwidth limitation.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Example: See Example"Configuring the noise generator" on page 487.
Manual operation: See "Bandwidth" on page 105
[:SOURce<hw>]:NOISe:DISTribution <Distribution>
Sets the distribution of the noise power density.
Parameters:
<Distribution> GAUSs | EQUal
*RST: GAUSs
Example: See Example"Configuring the noise generator" on page 487.
Manual operation: See "Distribution" on page 105
[:SOURce<hw>]:NOISe:LEVel:RELative?
Queries the level of the noise signal per Hz in the total bandwidth.
SOURce subsystem