Rohde & Schwarz R&S SMB100B - Preset, Set to Default and Factory Preset Settings

File and data management
R&S
®
SMB100B
198User Manual 1178.3711.02 ─ 08
(see Chapter 9.2.3, "How to recall user settings automatically after preset",
on page 199)
●
Store and reload user-defined instrument states
(see Chapter 9.4.2, "How to save and recall instrument settings", on page 205)
Mark / Do not mark parameters changed from preset
To survey the current state of the settings concerning default values, the
R&S SMB100B offers a feature that visually identifies deviations from the default val-
ues.
For more information, see Chapter 9.2.2, "How to identify parameters which are not in
a preset state", on page 199.
9.2.1 Preset, set to default and factory preset settings
Preset..........................................................................................................................198
Set To Default..............................................................................................................198
Preset this Parameter................................................................................................. 198
Execute Factory Preset...............................................................................................198
Preset
Resets all parameters and switching states, and closes all opened dialogs.
Note:
In contrast to the [Preset] key, the SCPI commands *RST and :SYSTem:PRESet do
not close open dialogs in the GUI.
Consider also the following possibilities:
●
You can define the settings that are restored when you preset the instrument
(see Chapter 9.2.3, "How to recall user settings automatically after preset",
on page 199)
●
You can reset the instrument to the factory state
(see "Execute Factory Preset" on page 198)
See also Table 9-1 that contains the key parameters that are reset by the correspond-
ing preset functions.
Remote command:
*RST on page 354
Set To Default
Resets the associated settings of the corresponding dialog or tab.
Preset this Parameter
Restores the default value of a single parameter.
Execute Factory Preset
Resets the instrument to its factory settings.
Note: "Factory Preset" retains all security settings and does not delete any user files
like setups or user data.
Restoring the (default) instrument configuration