Analog modulations
R&S
®
SMB100B
94User Manual 1178.3711.02 ─ 08
To fill the table, select "Fill".
Note: Once you enter a value or fill a column, the editor automatically adds preset val-
ues in the other columns. This functionality protects against data loss, otherwise
incomplete rows will be lost when saving. You can simply override these values.
"From / Range"
Defines the start line and number of lines to be filled.
"Column To Fill"
Selects, if the column is filled up with frequencies in Hz, levels in dBm
or dwell times in s.
"Start Value / End Value"
Sets the start value for frequency, level or dwell time. The end value
is read only and depends on the increment value and the range.
"Increment Value"
Determines the step size.
"Fill"
Fills the column specified in "Column To fill".
5.4.4.3 Import/export list files
Access:
1. Select one of the following:
● "Sweep" > "List mode".
● "Level" > "User Correction".
● "Modulation > Pulse Modulation > Pulse Generator > Pulse Mode = Train".
Modulation settings
To Next Page
Loading...
