Rohde & Schwarz R&S SMB100B - Connecting to Power; Connecting to LAN

Getting started
R&S
®
SMB100B
27User Manual 1178.3711.02 ─ 08
3.1.6 Connecting to power
For safety information, see "Connecting to power" on page 19.
1. Plug the AC power cable into the AC power connector on the rear panel. Only use
the AC power cable delivered with the R&S SMB100B.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
3.1.7 Connecting to LAN
Network environment
Before connecting the product to a local area network (LAN), consider the following:
●
Install the latest firmware to reduce security risks.
●
For internet or remote access, use secured connections if applicable.
●
Ensure that the network settings comply with the security policies of your company.
Contact your local system administrator or IT department before connecting your
product to your company LAN.
●
When connected to the LAN, the product may potentially be accessed from the
internet, which may be a security risk. For example, attackers might misuse or
damage the product.
To connect to LAN
► Connect the LAN socket on the rear panel via an RJ-45 cable to the LAN.
Using DHCP (dynamic host configuration protocol), the R&S SMB100B assigns the
IP address automatically.
If connected to the LAN, the R&S SMB100B displays the IP address and the host-
name at the left bottom of the home screen.
2
1
1
= Hostname
2 = IP address
If disconnected from the LAN, the R&S SMB100B displays the IP address 0.0.0.0.
See also Chapter 11.7, "To configure the instrument for remote access", on page 314.
Preparing for use