Rohde & Schwarz R&S SMB100B - LF Sweep Settings

Remote control commands
R&S
®
SMB100B
471User Manual 1178.3711.02 ─ 08
Parameters:
<Rise> float
Range: 1E-6 to 100
Increment: 10E-9
*RST: 0.5E-3
Example: See Example"Configuring the LF generator" on page 462.
Manual operation: See "Triangle Rise" on page 103
12.15.5.2 LF sweep settings
With the commands described in this section, you can configure the sweep of the LF
signal.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl................................................... 471
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute................................................471
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE....................................................472
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:POINts...................................................472
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace............................................... 472
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?..............................................473
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe...................................................473
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing................................................ 473
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic..................................473
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP[:LINear]........................................ 474
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:DWELl <Dwell>
Sets the dwell time for each frequency step of the sweep.
Parameters:
<Dwell> float
Range: 0.001 to 100
Increment: 100E-6
*RST: 0.01
Default unit: s
Example: See Example"Setup an LF sweep" on page 461.
Manual operation: See "Dwell Time" on page 133
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:EXECute
Immediately starts an LF sweep.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE determines which sweep
is executed, e.g. SOURce:LFOutput:SWEep:FREQuency:MODE STEP.
Example:
See Example"Setup an LF sweep" on page 461.
Usage: Event
Manual operation: See "Execute Single Sweep" on page 134
SOURce subsystem