Rohde & Schwarz R&S SMB100B - Page 473

Remote control commands
R&S
®
SMB100B
473User Manual 1178.3711.02 ─ 08
Parameters:
<State> 1 | ON | 0 | OFF
*RST: 0
Manual operation: See "Retrace" on page 131
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?
Queries the current status of the LF frequency sweep mode.
Return values:
<State> 1 | ON | 0 | OFF
Example: See Example"Setup an LF sweep" on page 461.
Usage: Query only
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe
<Shape>
Sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example"Setup an LF sweep" on page 461.
Manual operation: See "Shape" on page 131
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing <Spacing>
Selects linear or logarithmic sweep spacing.
Parameters:
<Spacing> LINear | LOGarithmic
*RST: LINear
Example: See Example"Setup an LF sweep" on page 461.
Manual operation: See "Spacing" on page 133
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:STEP:LOGarithmic
<Logarithmic>
Sets the step width factor for logarithmic sweeps to calculate the frequencies of the
steps.
For information on how the value is calculated and the interdependency with other
parameters, see Chapter 6.2.1, "Correlating parameters in sweep mode", on page 122
SOURce subsystem