Getting started
R&S
®
SMB100B
32User Manual 1178.3711.02 ─ 08
To disconnect from power
The R&S SMB100B is in the standby state.
1.
NOTICE! Risk of data loss. If you disconnect the product from power when it is in
the ready state, you can lose settings and data. Shut it down first.
Set the toggle switch on the power supply to position [0].
The LED of the [On/Standby] key is switched off.
2. Disconnect the R&S SMB100B from the power source.
3.2 Instrument tour
This chapter explains the control elements and the connectors of the R&S SMB100B.
The views of the front panel and the rear panel help you to get familiar with the instru-
ment and to perform first steps. For specifications of the interfaces, see the data sheet.
The meanings of the labels on the R&S SMB100B are described in Chapter 2.2,
"Labels on R&S SMB100B", on page 20.
3.2.1 Front panel tour
This section provides an overview of the control elements at the front panel of the
R&S SMB100B. Most of the connectors are at the rear panel and are described in
Chapter 3.2.2, "Rear panel tour", on page 36.
1 2 3 4 5 6
789
Figure 3-2: Front panel view
1 = Utility keys
2 = Touchscreen
3 = Function keys
4 = Navigation controls
5 = Display keys
6 = USB connector
Instrument tour
To Next Page
Loading...
