Rohde & Schwarz R&S SMB100B - Manual Operation Security Settings

General instrument functions
R&S
®
SMB100B
253User Manual 1178.3711.02 ─ 08
Sanitize
Executes the erase procedure that sanitizes the internal memory.
The sanitizing function makes sure that no user information is stored on the instrument
when it leaves the secure environment.
To apply the change: enter the security password and confirm with "Accept". Otherwise
the change has no effect.
Note: If the instrument is subject to high security, and you have disabled volatile mode,
the internal memory holds user-data, and thus poses a security risk.
See also Chapter 10.4, "Using the security settings", on page 248 for more information
on the security concept.
Remote command:
:SYSTem:SECurity:SANitize[:STATe] on page 535
10.4.2.3 Manual operation security settings
Access:
► Select "System Config > Setup > Security > Security > General > Manual Opera-
tion".
The "SW Update" tab enables you to lock front panel operation and/or reading the
display.
The remote commands available to control security settings are described in:
●
Chapter 12.9, "DISPlay subsystem", on page 382
●
Chapter 12.16, "SYSTem subsystem", on page 517.
Annotation Frequency
Enables the display of the currently used frequency in the status bar.
How to: see "Disabling the frequency and level indication in the status bar"
on page 262.
Remote command:
:DISPlay:ANNotation:FREQuency on page 384
Annotation Amplitude
Enables the display of the currently selected level in the status bar.
Using the security settings