Rohde & Schwarz R&S SMB100B - Protocol Settings

Network operation and remote control
R&S
®
SMB100B
299User Manual 1178.3711.02 ─ 08
● Protocol settings....................................................................................................299
● SNMP user settings.............................................................................................. 300
● Device tag settings................................................................................................304
11.5.8.1 Protocol settings
The "Protocol" tab of the "Enhanced HUMS Settings"" dialog provides protocol settings
for SNMP or REST protocol.
Access:
1. Select "System Config > Remote Access > HUMS".
2. Select "State > ON".
3. Select "Enhanced Settings".
4. Select "Protocol".
The dialog provides enhanced settings for configuring protocol settings and device
tags.
Settings
SNMP..........................................................................................................................299
REST...........................................................................................................................299
SNMP Configuration................................................................................................... 300
└ Location........................................................................................................ 300
└ Contact..........................................................................................................300
└ Access.......................................................................................................... 300
└ Community....................................................................................................300
User Settings...............................................................................................................300
SNMP
Enables the SNMP agent and selects the supported SNMP version to communicate
with the service.
The setting is reset by a factory preset to "v1/v2c".
"Off"
The SNMP agent is disabled.
"v1/v2c"
Selects SNMP version 2, which also enables version v1.
"v1/v2c/v3"
Selects all SNMP version v1, v2c and v3.
"v3"
Selects SNMP version v3.
Remote command:
SYSTem:COMMunicate:SNMP:VERSion on page 381
REST
Enables the REST API protocol.
The setting is reset by a factory preset to "On".
Remote command:
SYSTem:COMMunicate:REST:ENABle on page 378
Remote access settings