Getting started
R&S
®
SMB100B
37User Manual 1178.3711.02 ─ 08
1 2 3 4 5 6
8111213141516
7
9
10
Figure 3-4: Rear panel view R&S
SMB100B RF Signal Generator
1 = Serial number (six digits in the string 1400.1000.02-<serial number>-<checksum>)
2 = IEC 625/IEEE 488
3, 5 = USB/USB In
4 = LAN
6 = AC power supply connector and switch
7 = S/P Dif
8 = Stereo L/R
9, 10 = Ref In/Ref Out
11 = LF
12 = Mod. Ext.
13 = Pulse Video
14 = Pulse Ext.
15 = Signal Valid
16 = Inst Trig
3.2.2.1 Connectors
IEC 625/IEEE 488
Option: R&S SMBB-B86
General purpose interface bus (GPIB) interface for remote control of the instrument.
The interface is in compliance with the standards IEC 625, IEEE 488 and SCPI.
Use this interface to connect a computer for remote control of the R&S SMB100B. To
set up the connection, use high-quality shielded cables. See "Cable selection and elec-
tromagnetic interference (EMI)" on page 26.
See also Chapter C.1, "GPIB-Bus interface", on page 609 and Chapter 11, "Network
operation and remote control", on page 266.
USB/USB In
●
Female USB (universal serial bus) 2.0 connector of type A (host USB), to connect
devices like a keyboard, a mouse, a memory stick, or the R&S NRP-Z3/Z4 cable
for the R&S NRP power sensors
●
Option: R&S SMBB-B86
Female USB 3.0 connector of type Micro-B (USB In), for example, for remote con-
trol.
Instrument tour
To Next Page
Loading...
