Rohde & Schwarz R&S SMB100B - Page 38

Getting started
R&S
®
SMB100B
38User Manual 1178.3711.02 ─ 08
How to: Chapter 3.1.8, "Connecting USB devices", on page 28
LAN
RJ-45 connector to connect the R&S SMB100B to a LAN for remote control, remote
operation, and data transfer.
How to: Chapter 3.1.7, "Connecting to LAN", on page 27
AC power supply connector and switch
Mains power switch for performing the following tasks:
●
Connecting the internal power supply to the power source
●
Disconnecting the internal power supply from the power source
How to: Chapter 3.1.6, "Connecting to power", on page 27.
S/P Dif
Option: R&S SMBB-B5
BNC input connector for digital stereo signals.
See also Chapter 5.4.3, "Stereo modulation", on page 78.
Stereo L/R
Option: R&S SMBB-B5
BNC input connectors for analog stereo modulation signals. External modulation sour-
ces or the internal LF generator can be used.
See also Chapter 5.4.3, "Stereo modulation", on page 78.
Ref In/Ref Out
Input/output for external reference signal.
BNC connectors for reference signals from 1 MHz to 100 MHz.
SMA connectors for 1 GHz reference signals.
How to: Chapter 3.1.11, "Connecting to Ref In/Ref Out", on page 30
LF
BNC connector for output of the internal LF generator signal.
See the data sheet and in the user manual, section Chapter 5, "Analog modulations",
on page 68.
Mod. Ext.
BNC connector for input of external analog modulation signals.
See Chapter 5, "Analog modulations", on page 68.
Pulse Video
BNC connector for output of the internal pulse generator signal or the looped through
pulse signal from Pulse Ext. connector (video signal).
See Chapter 5.4.1, "Pulse modulation settings", on page 71.
Instrument tour