Getting started
R&S
®
SMB100B
49User Manual 1178.3711.02 ─ 08
3.4.3.1 Status bar
The status bar at the top of the screen indicates the RF frequency and the level of the
output signal provided to the DUT. You can set both parameters directly here.
3.4.3.2 Tile diagram
The tile diagram is the main entry to the settings of the R&S SMB100B.
Tile Access to:
"Modulation"
●
Analog and stereo
1)
, and pulse
1)
modulation settings
●
Built in LF generator
"System Config"
●
"Save/Recall": settings for saving and loading instrument configurations
●
"Remote access": Network and emulation settings.
●
"Setup": general system configuration
"Sweep"
●
Frequency and level sweeps
●
List mode
"Frequency"
●
RF frequency and phase
●
Reference frequency
"Level"
●
RF level
●
Attenuator
●
Automatic level control
●
User correction
"Power sensors"
●
Power sensors
1)
requires additional options
3.4.3.3 Taskbar
The "Taskbar" shows a home and an info button, and assigns a labeled button when-
ever you open a dialog. If more dialogs are open than the taskbar can display, touch
and swipe the taskbar to scroll up and down.
The buttons shown in the following example represent the variants.
Table 3-9: Example of buttons in the taskbar
"Home" button
Returns to the home screen.
"Busy" indicator
Indicates a running process.
"User Menu"
Lists parameters that can be defined for quick access.
Shows the current remote access connections when the instrument is remotely con-
trolled.
Tip: An indicator in the "System Config" tile shows the current remote control status.
Instrument control
To Next Page
Loading...
