Remote control commands
R&S
®
SMB100B
446User Manual 1178.3711.02 ─ 08
Manual operation: See "Traffic Program" on page 86
[:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:STATe] <State>
Activates the RDS traffic announcement.
If TP is on, this function switches the receiver from the current status, e.g. playing a
CD, to the receive mode and enables the broadcast of a traffic announcement.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "Traffic Announcement" on page 86
12.15.2 SOURce:CORRection subsystem
The SOURce:CORRection subsystem contains the commands for defining correction
values for external test assemblies.
You can acquire the correction values anytime, regardless of the modulation settings of
the generator. The correction is performed by adding the correction values to the out-
put level of the respective RF frequency.
Determine the correction values in one of the following ways:
●
Measure the RF output level at several frequency points and enter the value pairs
manually in a table
●
Connect an R&S NRP to the generator output signal and send the command [:
SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe to
fill the table automatically.
Correction values can be stored in files with the predefined file extension *.uco.
Refer to Chapter 12.5.2, "Accessing files in the default or in a specified directory",
on page 359 for general information on file handling in the default and in a specific
directory.
Programming example
The examples in this section assume that:
●
The files are stored in the default directory.
●
*RST does not affect data lists.
Example: Create a table with user-defined correction values for the RF level
The following example shows a command sequence to create and activate a list for
assigning level correction values to arbitrary RF frequencies. Further hardware settings
are not considered.
SOURce subsystem
To Next Page
Loading...
