Rohde & Schwarz R&S SMB100B - LXI Settings; LXI Status Settings

Network operation and remote control
R&S
®
SMB100B
307User Manual 1178.3711.02 ─ 08
See Chapter 11.14.3, "How to set up remote operation from a smart device",
on page 343.
11.6 LXI settings
On the R&S SMB100B, an LXI functionality is already installed and enabled, see LXI
status settings. Thus, you can access he instrument using any web browser to perform
the following tasks:
●
Modifying network configurations, see Chapter 11.6.2.1, "LAN configuration",
on page 309.
●
Accessing the instrument remotely
●
Analyzing SCPI remote diagnostics
11.6.1 LXI status settings
Access:
► Select "System Config > Setup > Remote Access > LXI Status".
The LXI "LAN Status" dialog shows the parameters of the LAN connection.
Alternatively, you can change the LAN settings using the LXI web browser interface,
see Chapter 11.6.2.1, "LAN configuration", on page 309.
LAN Status
The LED indicates the LXI status.
"green"
Normal operation
"green (flashing)"
Device identification
LXI settings