Rohde & Schwarz R&S SMB100B - FM, Phim and am Modulation Settings

Analog modulations
R&S
®
SMB100B
72User Manual 1178.3711.02 ─ 08
Settings:
State..............................................................................................................................72
Source...........................................................................................................................72
Transition Type..............................................................................................................72
State
Activates pulse modulation and triggers the following automatic settings:
●
Pulse generator is activated.
The signal is output at the Pulse Video connector.
To deactivate the signal output, set "Pulse Generator" > Pulse Output State > "Off".
Remote command:
[:SOURce<hw>]:PULM:STATe on page 431
Source
Selects between the internal "Pulse Generator" or an "External" pulse signal for the
modulation.
"Pulse Generator"
Selects the internal generator.
See Pulse generator.
"External"
Modulation source is fed to the input connector.
See "Signal sources" on page 68.
Remote command:
[:SOURce<hw>]:PULM:SOURce on page 431
Transition Type
Selects between "Fast" or "Smoothed" slew rate (slope).
"Fast"
Enables fast transitions with shortest rise and fall times.
"Smoothed"
Flattens the slew rate, resulting in longer rise / fall times. Use this
mode if you are working with devices that are sensitive to steep
slopes.
Remote command:
[:SOURce<hw>]:PULM:TTYPe on page 431
5.4.2 FM, PhiM and AM modulation settings
Option: R&S SMBB-K720
Modulation settings