Rohde & Schwarz R&S SMB100B - Network Operation and Remote Control

Network operation and remote control
R&S
®
SMB100B
266User Manual 1178.3711.02 ─ 08
11 Network operation and remote control
As an alternative to the interactive operation directly at the instrument, you can operate
the R&S SMB100B also from a remote location.
The various interfaces provide flexible access to the instrument, such as remote con-
trol, remote operation or remote file access. These remote access modes are funda-
mentally different, although they are often considered interchangeable, as described in
Overview of remote access modes.
Figure 11-1 shows the possibilities of the physical connection (interfaces) for remote
access.
The following descriptions provide information required for operating the
R&S SMB100B remotely. The information applies to all applications and operating
modes supported by the instrument. Definitions specified in the SCPI standard are not
provided.
For basic knowledge on remote control operation and additional information, see the
following documents, available on the Rohde & Schwarz website:
●
Remote control via SCPI
●
1GP72: Connectivity of Rohde&Schwarz Signal Generators
●
1MA208: Fast Remote Instrument Control with HiSLIP
Figure 11-1: Supported remote connections
● Overview of remote access modes.......................................................................267
● Remote control interfaces and protocols...............................................................268
● Remote control programs and libraries.................................................................273
● Status reporting system........................................................................................ 276
● Remote access settings........................................................................................284
● LXI settings........................................................................................................... 307
● To configure the instrument for remote access..................................................... 314
● To establish a remote control session over LAN...................................................319
● To establish a remote control session over GPIB................................................. 328
● To establish a remote control session over USB...................................................328