Remote control commands
R&S
®
SMB100B
357User Manual 1178.3711.02 ─ 08
Example:
SOUR:PRES
Presets all settings that are related to signal path
Usage: Event
:SYSTem:PRESet
Triggers an instrument reset. It has the same effect as:
●
The [Preset] key.
However, the command does not close open GUI dialogs like the key does.
●
The *RST command
For an overview of the settings affected by the preset function, see Table 9-1
Example:
SYST:PRES
All instrument settings (also the settings that are not currently
active) are reset to their default values.
Usage: Setting only
:SYSTem:FPReset
Triggers an instrument reset to the original state of delivery.
Example:
SYST:FPR
All instrument settings (also the settings that are not currently
active) are reset to the factory values.
Usage: Event
Manual operation: See "Execute Factory Preset" on page 198
12.5 MMEMory subsystem
The MMEMory subsystem (Mass MEMory) contains the commands for managing files
and directories as well as for loading and saving complete instrument settings in files.
Mass storage location
Without any additional measures, the R&S SMB100B stores user files on the internal
memory or if connected, on a memory stick.
Both, the user directory /var/user/ on the internal memory or the /usb/ directory
on the memory stick, can be used to preserve user-defined data. Any directory struc-
ture can be created.
The /var/volatile directory serves as a RAM drive and can be used to protect
sensitive information. The data is available temporarily.
Default storage location
The R&S SMB100B stores user data in the user directory.
MMEMory subsystem
To Next Page
Loading...
