Rohde & Schwarz R&S SMB100B - List Mode Data Settings

List and sweep mode
R&S
®
SMB100B
141User Manual 1178.3711.02 ─ 08
Global Dwell Time
Sets the dwell time for Dwell Time Mode > "Global".
Note: In case of considerable overrun conditions, the R&S SMB100B turns off the list
mode.
See also "Dwell time" on page 127.
Remote command:
[:SOURce<hw>]:LIST:DWELl on page 477
Trigger Slope
For "Mode = Extern Step/Single", selects the polarity of the active slope of an applied
instrument trigger.
Trigger signal is expected at the Inst Trig connector.
"Positive"
The rising edge of the trigger signal triggers the instrument.
"Negative"
The falling edge of the trigger signal triggers the instrument.
Remote command:
[:SOURce]:INPut:TRIGger:SLOPe on page 461
Reset
Resets the list to the starting point.
Remote command:
[:SOURce<hw>]:LIST:RESet on page 484
Execute Single
Manually starts list processing in "Single" mode.
Remote command:
[:SOURce<hw>]:LIST:TRIGger:EXECute on page 481
6.6.2 List mode data settings
Access:
1. Select "Sweep" > "List mode".
2. Select "List Mode Data".
This dialog contains the parameters required for creating and editing lists, activat-
ing the learning function and selecting the list processing mode.
List mode settings