Rohde & Schwarz R&S SMB100B - General Settings

List and sweep mode
R&S
®
SMB100B
139User Manual 1178.3711.02 ─ 08
Access:
► Select "Sweep" > "List mode".
The dialog contains parameters for configuring the list mode processing, entering
list mode data and transferring data files from or to the instrument.
The remote commands required to define these settings are described in Chap-
ter 12.15.6, "SOURce:LIST subsystem", on page 474.
● General settings....................................................................................................139
● List mode data settings......................................................................................... 141
● Import/export settings............................................................................................142
6.6.1 General settings
Access:
► Select "Sweep" > "List mode".
In the "General" tab, you can configure the trigger and dwell time modes for list
processing and activate signal generation.
Settings
State............................................................................................................................140
Current Index.............................................................................................................. 140
Mode........................................................................................................................... 140
Dwell Time Mode.........................................................................................................140
Global Dwell Time....................................................................................................... 141
Trigger Slope...............................................................................................................141
Reset...........................................................................................................................141
Execute Single............................................................................................................ 141
List mode settings