Rohde & Schwarz R&S SMB100B - Source:noise Subsystem

Remote control commands
R&S
®
SMB100B
487User Manual 1178.3711.02 ─ 08
[:SOURce<hw>]:LIST:DEXChange:MODE <Mode>
Determines the import or export of a list.
Specify the source or destination file with the command [:SOURce<hw>]:LIST:
DEXChange:SELect.
Parameters:
<Mode> IMPort | EXPort
*RST: IMPort
Example: See Example"List mode data exchange" on page 476.
Manual operation: See "Mode" on page 95
[:SOURce<hw>]:LIST:DEXChange:SELect <Filename>
Selects the ASCII file for import or export, containing a list.
Parameters:
<Filename> string
Filename or complete file path; file extension can be omitted.
Example: See Example"List mode data exchange" on page 476.
Manual operation: See "Select Source/Select ASCII Destination" on page 96
12.15.7 SOURce:NOISe subsystem
The SOURce:NOISe subsystem contains the commands for:
●
Setting the noise modulation signal. The noise generator is optional.
Example: Configuring the noise generator
SOURce1:NOISe:DISTribution GAUSs
SOURce1:NOISe:BANDwidth 10000000
SOURce1:NOISe:BANDwidth:STATe 1
SOURce1:LFOutput1:SOURce NOIS
SOURce1:LFOutput1:STATe 1
SOURce1:NOISe:LEVel:RELative?
// -83.86
SOURce1:NOISe:LEVel:ABSolute?
// -13.86
● Noise generator.....................................................................................................488
SOURce subsystem