RF signal configuration
R&S
®
SMB100B
62User Manual 1178.3711.02 ─ 08
Remote command:
[:SOURce<hw>]:FREQuency:OFFSet on page 457
Multiplier
Sets the multiplication factor for the RF frequency.
This value represents the multiplication factor of a downstream instrument, as for
example a multiplier. You can also assign a negative multiplication factor, for example
-1.0 to support frequency converters working in the reverse frequency position.
The "Frequency" value displayed in the status bar is the resulting frequency, as it is at
the output of the downstream instrument. The frequency at the R&S SMB100B RF out-
put is not changed.
See "RF frequency and level display with a downstream instrument" on page 59.
Remote command:
[:SOURce<hw>]:FREQuency:MULTiplier on page 457
User Variation
Defines and activates a user-defined step width for varying the RF frequency or RF
level with the rotary knob.
If disabled, the step width varies in steps of one unit at the cursor position.
Variation Active ← User Variation
Activates the set user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP:MODE on page 459
[:SOURce<hw>]:POWer:STEP:MODE on page 497
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 460
[:SOURce<hw>]:POWer:STEP[:INCRement] on page 497
4.4 RF level settings
Access:
1. Select "Level" > "RF Level".
RF level settings
To Next Page
Loading...
