RF signal configuration
R&S
®
SMB100B
63User Manual 1178.3711.02 ─ 08
In the "RF Level" dialog, you can configure the offset-free level, the level limit, and
the step width for varying the level with the rotary knob.
2. Select "User Variation" to set the step width to be used when .setting the RF level
using the rotary knob.
3. Observe the information on the home screen, "Level" tile.
The "Level" tile indicates the level limit, the user correction status and current cor-
rection value, current setting characteristics incl. mode.
The remote commands required to define the settings are described in Chap-
ter 12.15.10, "SOURce:POWer subsystem", on page 491.
RF level settings
To Next Page
Loading...
