Rohde & Schwarz R&S SMB100B - Page 445

Remote control commands
R&S
®
SMB100B
445User Manual 1178.3711.02 ─ 08
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "ARI BK" on page 84
[:SOURce]:STEReo:RDS:STATe <State>
Activates/deactivates the RDS signal generation. RDS signals can be generated simul-
taneously with MPX (FM stereo multiplex) and ARI signals.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "RDS State" on page 85
[:SOURce]:STEReo:RDS[:DEViation]
<Deviation>
Sets the deviation of the RDS subcarrier.
Parameters:
<Deviation> integer
Range: 0 to 10 kHz
*RST: 2 kHz
Example: See Chapter 12.15.1.6, "SOURce:STEReo subsystem",
on page 438.
Manual operation: See "RDS Deviation" on page 85
[:SOURce]:STEReo:RDS:DATaset <Dataset>
Selects one of the five data sets provided on the instrument for use in the RDS signal.
Parameters:
<Dataset> DS1 | DS2 | DS3 | DS4 | DS5
*RST: DS1
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "RDS Data Set" on page 85
[:SOURce]:STEReo:RDS:TRAFfic:PROGram[:STATe] <State>
Activates the RDS traffic program. The receiver can recognize a frequency as being
capable of traffic information only if the TP function is active.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
SOURce subsystem