Rohde & Schwarz R&S SMB100B - Page 444

Remote control commands
R&S
®
SMB100B
444User Manual 1178.3711.02 ─ 08
[:SOURce]:STEReo:ARI:TYPE:STATe <State>
Activates/deactivates the Stereo ARI Identifier. Activating selects the previously
selected identifier type.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "ARI Identification" on page 84
[:SOURce]:STEReo:ARI:TYPE <Type>
Selects the generated identifiers of the ARI signal.
DK and BK are abbreviations of the German words Durchsagekennung and Bereich-
skennung.
Parameters:
<Type> OFF | DK | BK | BKDK
OFF
Only the 57 kHz subcarrier is generated.
DK
The message identification is generated in addition (low-fre-
quency 30% AM).
BK
The area identification is generated in addition (60% AM). The
specific code is selected in [:SOURce]:STEReo:ARI:BK[:
CODE] on page 444.
BKDK
The area and message identification are generated in addition.
The BK code is selected in [:SOURce]:STEReo:ARI:BK[:
CODE] on page 444.
*RST:
OFF
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "ARI Identification" on page 84
[:SOURce]:STEReo:ARI:BK[:CODE] <Code>
Selects the area identification (BK) code of the ARI signal. The code is generated if the
BK or DK+BK identifier of the ARI signal is activated.
Parameters:
<Code> A | B | C | D | E | F
The six letters (six different frequencies) identify a specific
region in each country.
*RST: A
SOURce subsystem