Rohde & Schwarz R&S SMB100B - Page 443

Remote control commands
R&S
®
SMB100B
443User Manual 1178.3711.02 ─ 08
Parameters:
<Deviation> integer
Range: 0 to 10 kHz
*RST: 6.75 kHz
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "Pilot Deviation" on page 83
[:SOURce]:STEReo:PILot:PHASe <Phase>
Sets the phase of the pilot tone in degrees, in relation to the 38 kHz carrier signal of
the receiver. For a correct demodulation, the pilot tone must be in phase with the 38
kHz carrier.
Parameters:
<Phase> float
Range: -5 to 5
Increment: 0.1
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "Pilot Phase" on page 83
[:SOURce]:STEReo:ARI:STATe <State>
Activates/deactivates the ARI signal generation. ARI signals can be generated simulta-
neously with MPX and RDS signals.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "ARI State" on page 84
[:SOURce]:STEReo:ARI[:DEViation] <Deviation>
Sets the frequency deviation of the ARI subcarrier signal.
Parameters:
<Deviation> integer
Range: 0 to 10000
*RST: 3500
Example: See Example"Activating stereo modulation" on page 438.
Manual operation: See "ARI Deviation" on page 84
SOURce subsystem