Rohde & Schwarz R&S SMB100B - Page 262

General instrument functions
R&S
®
SMB100B
262User Manual 1178.3711.02 ─ 08
2. Select "LAN > Off".
All LAN connections and hence all LAN services are disabled.
Disabling LAN services
1. Select "System Config > Setup > Security > Security > LAN Services > Main Ser-
vices".
2. Select, for example, "FTP > Off" or "VNC > Off".
3. Enter the Security Password.
4. Select "Accept".
Activating SMB version 1.0/2.0 client and server
By default, support of SMB client and SMB server of the SMB protocol versions 1.0
and 2.0 is deactivated.
Activate support only, if needed:
1. Select "System Config > Setup > Security > Security > LAN Services > Samba Ser-
vices".
2. Select "SMB 1.0/2.0 Client > On" and "SMB 1.0/2.0 Server > On".
3. Enter the Security Password.
4. Select "Accept".
Disabling the frequency and level indication in the status bar
These settings are useful to prevent unauthorized personnel from reading the display,
when you remotely control the instrument from a different location.
1. Select "System Config > Setup > Security > General > Manual Operation".
2. Select "Annotation Frequency > Off" or "Annotation Amplitude > Off".
3. Enter the Security Password.
4. Select "Accept".
Deactivating the user interface
1. Select "System Config > Setup > Security > General > Manual Operation".
2. Select "User Interface > Disabled".
3. Enter the Security Password.
4. Select "Accept".
The screen shuts off and displays a padlock symbol
instead.
There are further possible configurations. For details, see "User Interface"
on page 254.
Using the security settings