Rohde & Schwarz R&S SMB100B - Page 132

List and sweep mode
R&S
®
SMB100B
132User Manual 1178.3711.02 ─ 08
"Sawtooth"
The sweep runs from start to stop frequency. The subsequent sweep
starts at the start value, i.e. the shape of the sweep sequence resem-
bles a sawtooth.
Figure 6-11: Sweep signal sawtooth shape
1 = Start value
2 = Stop value
3 = Step width
"Triangle"
The sweep runs from start to stop value and back, i.e. the shape of
the sweep resembles a triangle. Each subsequent sweep starts at the
start frequency.
Figure 6-12: Sweep signal triangle shape
1 = Start value
2 = Stop value
3 = Step width
Remote command:
RF frequency sweep:
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe on page 512
RF level sweep:
[:SOURce<hw>]:SWEep:POWer:SHAPe on page 512
RF combined sweep:
[:SOURce<hw>]:SWEep:COMBined:SHAPe on page 516
Sweep mode settings