Rohde & Schwarz R&S SMB100B - Page 453

Remote control commands
R&S
®
SMB100B
453User Manual 1178.3711.02 ─ 08
Parameters:
<Column> TABulator | SEMicolon | COMMa | SPACe
*RST: COMMa
Example: See Example"User correction data exchange" on page 448 .
Manual operation: See "ASCII File Settings" on page 95
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:DECimal <Decimal>
Sets the decimal separator used in the ASCII data between '.' (decimal point) and ','
(comma) with floating-point numerals.
Parameters:
<Decimal> DOT | COMMa
*RST: DOT
Example: See Example"User correction data exchange" on page 448 .
Manual operation: See "ASCII File Settings" on page 95
[:SOURce<hw>]:CORRection:DEXChange:EXECute
Executes the import or export of the selected correction list, according to the previously
set transfer direction with command [:SOURce<hw>]:CORRection:DEXChange:
MODE.
Example:
See Example"User correction data exchange" on page 448 .
Usage: Event
Manual operation: See "Import / Export" on page 96
[:SOURce<hw>]:CORRection:DEXChange:MODE <Mode>
Determines import or export of a user correction list.
Specify the source or destination file with the command [:SOURce<hw>]:
CORRection:DEXChange:SELect.
Parameters:
<Mode> IMPort | EXPort
*RST: IMPort
Example: See Example"User correction data exchange" on page 448 .
Manual operation: See "Mode" on page 95
[:SOURce<hw>]:CORRection:DEXChange:SELect <Filename>
Selects the ASCII file for import or export, containing a user correction list.
SOURce subsystem