Rohde & Schwarz R&S SMB100B - Page 383

Remote control commands
R&S
®
SMB100B
383User Manual 1178.3711.02 ─ 08
:DISPlay:ANNotation[:ALL]..............................................................................................385
:DISPlay:DIALog:ID?......................................................................................................385
:DISPlay:DIALog:OPEN..................................................................................................386
:DISPlay:DIALog:CLOSe................................................................................................ 386
:DISPlay:DIALog:CLOSe:ALL..........................................................................................386
:DISPlay:PSAVe:HOLDoff <HoldoffTimeMin>
Sets the wait time for the screen saver mode of the display.
Parameters:
<HoldoffTimeMin> integer
Range: 1 to 60
*RST: n.a. (factory preset: 10)
Default unit: minute
Example: see Example"Activating screen saver mode and display update"
on page 382
Manual operation: See "Wait Time" on page 229
:DISPlay:PSAVe[:STATe] <State>
Activates the screen saver mode of the display.
We recommend that you use this mode to protect the display, if you operate the instru-
ment in remote control.
To define the wait time, use the command :DISPlay:PSAVe:HOLDoff.
Parameters:
<State> 1 | ON | 0 | OFF
*RST: n.a. (factory preset: 0)
Example: See Example"Activating screen saver mode and display update"
on page 382
Manual operation: See "Screen Saver" on page 229
:DISPlay:BRIGhtness <BRIGhtness>
Sets the brightness of the dispaly.
Parameters:
<BRIGhtness> float
Range: 1.0 to 20.0
Increment: 1.0
*RST: 14.0
Example:
DISPlay:BRIGhtness 14
Manual operation: See "Display" on page 229
DISPlay subsystem