Rohde & Schwarz R&S SMB100B - Page 513

Remote control commands
R&S
®
SMB100B
513User Manual 1178.3711.02 ─ 08
[:SOURce<hw>]:SWEep:POWer:RUNNing?
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?
Queries the current sweep state.
Return values:
<State> 1 | ON | 0 | OFF
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Usage: Query only
[:SOURce<hw>]:SWEep[:FREQuency]:STEP:LOGarithmic <Logarithmic>
Sets a logarithmically determined step width for the RF frequency sweep. The value is
added at each sweep step to the current frequency.
See Chapter 6.2.1, "Correlating parameters in sweep mode", on page 122.
Parameters:
<Logarithmic> float
The unit is mandatory.
Range: 0.01 to 100
Increment: 1E-3
*RST: 1
Default unit: PCT
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Step Linear/Step Logarithmic" on page 136
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear] <Linear>
Sets the step width for linear sweeps.
See Chapter 6.2.1, "Correlating parameters in sweep mode", on page 122.
Omit the optional keywords so that the command is SCPI-compliant.
Parameters:
<Linear> float
Range: 0.001 Hz to (STOP - STARt)
Increment: 0.01
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Step Linear/Step Logarithmic" on page 136
[:SOURce<hw>]:COMBined:FREQuency:STARt <CombFreqStart>
Sets the start frequency of the combined RF frequency / level sweep.
SOURce subsystem