Rohde & Schwarz R&S SMB100B - Page 514

Remote control commands
R&S
®
SMB100B
514User Manual 1178.3711.02 ─ 08
See Chapter 6.2.1, "Correlating parameters in sweep mode", on page 122.
Parameters:
<CombFreqStart> float
Range: -59999E5 to 12E9
Increment: 0.01
*RST: 100E6
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Start Frequency/Stop Frequency" on page 135
[:SOURce<hw>]:COMBined:FREQuency:STOP
<CombFreqStop>
Sets the end frequency of the combined RF frequency / level sweep.
Parameters:
<CombFreqStop> float
Range: -59999E5 to 12E9
Increment: 0.01
*RST: 500E6
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Start Frequency/Stop Frequency" on page 135
[:SOURce<hw>]:COMBined:POWer:STARt <CombPowStart>
Sets the start level value of the combined RF frequency / level sweep.
See Chapter 6.2.1, "Correlating parameters in sweep mode", on page 122.
Parameters:
<CombPowStart> float
Range: -245 to 120
Increment: 0.01
*RST: -30
Example: See Example"Setup an RF frequency or power sweep"
on page 506.
Manual operation: See "Start Level / Stop Level" on page 137
[:SOURce<hw>]:COMBined:POWer:STOP <CombPowStop>
Sets the stop level value of the combined RF frequency / level sweep.
SOURce subsystem