Rohde & Schwarz R&S SMB100B - Page 532

Remote control commands
R&S
®
SMB100B
532User Manual 1178.3711.02 ─ 08
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK <Mask>
Sets the subnet mask.
Parameters:
<Mask> string
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "Subnet Mask" on page 288
:SYSTem:COMMunicate:SERial:BAUD <Baud>
Defines the baudrate for the serial remote control interface.
Parameters:
<Baud> 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200
*RST: n.a. (factory preset: 115200)
Example: See Example"Finding out VISA resource strings" on page 518.
Manual operation: See "Baud Rate" on page 292
:SYSTem:COMMunicate:SERial:PARity <Parity>
Enters the parity for the serial remote control interface.
Parameters:
<Parity> NONE | ODD | EVEN
*RST: n.a. (factory preset: NONE)
Example: See Example"Finding out VISA resource strings" on page 518.
Manual operation: See "Parity" on page 292
:SYSTem:COMMunicate:SERial:RESource?
Queries the visa resource string for the serial remote control interface. This string is
used for remote control of the instrument.
Return values:
<Resource> string
Example: See Example"Finding out VISA resource strings" on page 518.
Usage: Query only
Manual operation: See "SERIAL" on page 291
:SYSTem:COMMunicate:SERial:SBITs <SBits>
Defines the number of stop bits for the serial remote control interface.
SYSTem subsystem