Rohde & Schwarz R&S SMB100B - Page 531

Remote control commands
R&S
®
SMB100B
531User Manual 1178.3711.02 ─ 08
:SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname <Hostname>
Sets an individual hostname for the RF signal generator.
Note:We recommend that you do not change the hostname to avoid problems with the
network connection. If you change the hostname, be sure to use a unique name.
This is a password-protected function. Unlock the protection level 1 to access it.
Parameters:
<Hostname> string
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "Hostname" on page 287
:SYSTem:COMMunicate:NETWork[:COMMon]:WORKgroup
<Workgroup>
Sets an individual workgroup name for the instrument.
Parameters:
<Workgroup> string
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "Workgroup" on page 288
:SYSTem:COMMunicate:NETWork[:IPADdress]:DNS <DNS>
Determines or queries the network DNS server to resolve the name.
Parameters:
<DNS> string
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "DNS Server" on page 289
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway <Gateway>
Sets the IP address of the default gateway.
Parameters:
<Gateway> string
Range: 0.0.0.0 to ff.ff.ff.ff
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "Default Gateway" on page 289
SYSTem subsystem