Network operation and remote control
R&S
®
SMB100B
289User Manual 1178.3711.02 ─ 08
The TCP/IP protocol is preinstalled with the subnet mask 255.255.255.0. If the DHCP
server is available Address Mode A AUTO (DHCP), the setting is read-only. The sub-
net mask consists of four number blocks separated by dots. Each block contains 3
numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are allowed
in a block (as an example see the preinstalled address).
To assign the subnet mask manually, select Address Mode > Static.
Note: When assigning the subnet mask manually, make sure that the address matches
with the subnet mask of the controlling host interface.
How to:
"To assign the IP address manually on the instrument" on page 316.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK on page 532
Default Gateway
Displays the gateway address.
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
To assign the gateway address manually, select Address Mode > "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway on page 531
DNS Suffix
Displays the primary DNS (Domain Name System) suffix, that means the DNS name
without the hostname part.
The DNS system uses the suffix for registration and name resolution for unique identifi-
cation of the instrument in the entire network.
To assign the DNS suffix manually, select Address Mode > "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:COMMon]:DOMain on page 530
DNS Server
Determines the preferred server for name resolution. The DNS server contains the
underlying numerical values that are required for name resolution of the hostname as
part of the IP address.
To select the DNS server manually, select Address Mode > "Static".
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:DNS on page 531
MAC Address
Indicates the MAC (Media Access Control) address, a unique identifier of the network
adapter in the R&S SMB100B.
Remote command:
:SYSTem:COMMunicate:NETWork:MACaddress on page 529
Remote access settings
To Next Page
Loading...
