Rohde & Schwarz R&S SMB100B - Page 529

Remote control commands
R&S
®
SMB100B
529User Manual 1178.3711.02 ─ 08
Example: See Example"Finding out VISA resource strings" on page 518.
Manual operation: See "GPIB Channel Address" on page 292
:SYSTem:COMMunicate:HISLip:RESource?
Queries the VISA resource string. This string is used for remote control of the instru-
ment with HiSLIP protocol.
Return values:
<Resource> string
Example: See Example"Finding out VISA resource strings" on page 518.
Usage: Query only
Manual operation: See "HISLIP" on page 290
See "GPIB" on page 291
:SYSTem:COMMunicate:NETWork:IPADdress
<IpAddress>
Sets the IP address.
Parameters:
<IpAddress> string
Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "IP Address" on page 288
:SYSTem:COMMunicate:NETWork:IPADdress:MODE <Mode>
Selects manual or automatic setting of the IP address.
Parameters:
<Mode> AUTO | STATic
*RST: n.a. (factory preset: AUTO)
Example: See Example"Retrieving information on network-related set-
tings" on page 518.
Manual operation: See "Address Mode" on page 288
:SYSTem:COMMunicate:NETWork:MACaddress <MacAddress>
Queries the MAC address of the network adapter.
This is a password-protected function. Unlock the protection level 1 to access it.
Parameters:
<MacAddress> string
SYSTem subsystem