Remote control commands
R&S
®
SMB100B
432User Manual 1178.3711.02 ─ 08
[:SOURce<hw>]:PULM:OUTPut:SYNC[:STATe] <Sync>
Routes the pulse modulation signal to the [Signal Valid] connector.
Parameters:
<Sync> 1 | ON | 0 | OFF
*RST: OFF
Options: R&S SMBB-K23 (Pulse Generator)
Manual operation: See "Pulse Sync Out" on page 90
[:SOURce<hw>]:PULM:POLarity
<Polarity>
Sets the polarity of the externally applied modulation signal.
Parameters:
<Polarity> NORMal | INVerted
NORMal
Suppresses the RF signal during the pulse pause.
INVerted
Suppresses the RF signal during the pulse.
*RST: NORMal
Example: See Example"Perform pulse modulation" on page 427.
Manual operation: See "Polarity" on page 98
[:SOURce<hw>]:PULM:IMPedance <Impedance>
Sets the impedance for the external pulse trigger and pulse modulation input.
Parameters:
<Impedance> G50 | G10K
*RST: G10K
Example: See Example"Perform pulse modulation" on page 427.
Manual operation: See "Impedance" on page 98
Pulse train settings
Option: R&S SMBB-K27
This section describes the commands for the pulse train modulation and the associ-
ated file handling.
See Chapter 5.4.4.2, "Pulse generator > pulse train settings", on page 91.
Example: Generating a pulse train signal
The following settings are required to perform pulse train modulation.
SOURce subsystem
To Next Page
Loading...
