Rohde & Schwarz R&S SMB100B - Page 175

Improving level performance
R&S
®
SMB100B
175User Manual 1178.3711.02 ─ 08
The "Overview" tab shows the list of detected sensors, and provides a separate tab
per sensor.
A sensor tab contains all parameters for configuring the sensor settings, like aver-
age or peak display, reference source, filter and level offset.
The remote commands required to define these settings are described in Chap-
ter 12.14, "SENSe, READ, INITiate and SLISt subsystems", on page 396, including
the triggering of the measurement and the retrieval of measurement results.
See also Chapter 7.5, "How to calibrate the power level with an R&S NRP power
sensor", on page 180.
Settings
Sensor type and serial number................................................................................... 176
Level (Peak) / Level (Average)....................................................................................176
Sensor Mapping..........................................................................................................176
Sensor settings........................................................................................................... 176
└ State..............................................................................................................176
└ Zero...............................................................................................................176
Using power sensors