Rohde & Schwarz R&S SMB100B - Page 185

Reference oscillator
R&S
®
SMB100B
185User Manual 1178.3711.02 ─ 08
In the "Reference Frequency" tab, you can select the reference frequency signal
source and the frequency and synchronization bandwidth mode of an external ref-
erence signal.
2. Observe the information on the home screen, "Frequency" tile.
Observe the information on the home screen, "Measurement Setup" tile.
The "Frequency" tile indicates the current reference oscillator configuration, incl.
the reference oscillator source, external reference frequency (rounded value) and
output connector. A warning symbol in the "Frequency" tile indicates a missing
external source.
The remote commands required to define these settings are described in Chap-
ter 12.15.11, "SOURce:ROSCillator subsystem", on page 500.
Settings:
Set to Default.............................................................................................................. 186
Source.........................................................................................................................186
Show Connector..........................................................................................................186
Reference frequency settings