File and data management
R&S
®
SMB100B
219User Manual 1178.3711.02 ─ 08
To access the file system over SMB
We assume that the instrument and the remote PC are connected to a LAN.
1. Enable file transfer via FTP
2. Enable write permission on the file system
3. On the remote PC, start the Windows Explorer.
4. In the address field, enter //<"IP Address" of the Instrument>, e.g. ftp://
10.124.0.166.
Tip: The R&S SMB100B indicates its IP address on the home screen.
The user directory corresponds to the /var/user/ directory of the instrument;
the volatile directory - to the /var/volatile directory.
To map the R&S SMB100B as a network drive to the remote PC
We assume that the instrument and the remote PC are connected to a LAN.
1. Enable file transfer via SMB (Samba)
2. Enable write permission on the file system
3. On the remote PC, start the Windows Explorer.
Open the "Map Network Drive" dialog.
a) Select a valid "Drive", e.g. W.
b) In the "Folder" field, enter //<"IP Address" of the Instrument>/user
or //<"Hostname" of the Instrument>/user
For example: //10.124.0.166/user or //SMB100B-102030/user.
Tip: The R&S SMB100B indicates its IP address on the screen.
c) Select "Finish".
A log-on dialog opens and requests a user name and a password.
Tip:
Default password
The FTP and SAMBA file access use the user "instrument" with default password
"instrument".
We recommend that you change this password in the "Setup > Security > Pass-
word Management > Change User Password" dialog before connecting the instru-
ment to the network.
See Chapter 10.4.4, "Password management", on page 258.
How to transfer files from and to the instrument
To Next Page
Loading...
