Network operation and remote control
R&S
®
SMB100B
318User Manual 1178.3711.02 ─ 08
To disable LAN access in general
1. Select "System Config > Setup > Security".
2. Select "Security".
3. Select "LAN Services".
4. Disable "LAN" state.
5. Enter the Security Password.
6. Select "Accept".
When disabled, communication over the LAN connection is not possible.
To disable LAN services individually
1. Select "System Config > Setup > Security".
2. Select "Security".
3. Select "LAN Services".
4. Enable "LAN" state.
5. In the "Common Services" side tab, uncheck all services you want to block.
6. Select the "Samba Services" sidetab.
To configure the instrument for remote access
To Next Page
Loading...
