Getting started
R&S
®
SMB100B
43User Manual 1178.3711.02 ─ 08
a) Set "Start Freq > 200 MHz" and "Stop Freq > 600 MHz" to determine the fre-
quency sweep range.
b) Set the step width "Step Lin > 10.0 MHz" to determine the width for a frequency
step.
6. In the "General" tab, activate the frequency sweep with "State > On".
7. Close the sweep dialog.
(Alternatively, tap the "Home" button to minimize the dialog. The R&S SMB100B
indicates the "Sweep" dialog as active dialog in the task bar.)
8. To activate the RF signal output, select "Level" > "RF On".
Figure 3-6: Generating a frequency sweep signal
The frequency field in the status bar indicates the continuously changing frequency,
i.e. the running sweep.
Trying out the instrument
To Next Page
Loading...
