Rohde & Schwarz R&S SMB100B - Page 45

Getting started
R&S
®
SMB100B
45User Manual 1178.3711.02 ─ 08
4. In the "Save/Recall" dialog, select "Operation Mode > Recall".
Navigate to the directory the file is saved in and select the MyTestSignal file.
5. Tap the "Recall" button.
All instrument settings are restored and the display resembles Chapter 3.3.2, "Gen-
erating an RF frequency sweep signal", on page 42, which shows the instrument
display right before the settings were saved.
How to display all parameters with values different to their preset values
When you load a file to your instrument, you do not have enough information on the
changed settings. In such case, it is useful to visualize all parameters that have been
changed from their default state.
Try out the following:
●
Touch and hold a spot in the tile diagram for at least 1 second to access the con-
text-sensitive menu.
●
Select "Mark All Parameters Changed from Preset".
Trying out the instrument