Troubleshooting and notifications
R&S
®
SMB100B
574User Manual 1178.3711.02 ─ 08
Remote command:
:SYSTem:ERRor:ALL? or
:SYSTem:ERRor:CODE[:NEXT]?
13.1.2 Permanent notifications
Permanent notifications are displayed if an error occurs that impairs further instrument
operation, e.g. a hardware fault. The error signaled by a permanent notification must
be eliminated before correct instrument operation can be continued.
The message is displayed until the error is eliminated. It covers the status display in
the info line. After error elimination, the message automatically disappears and is also
recorded in the history.
Remote command:
:SYSTem:ERRor:STATic?
13.2 SCPI notifications
The SCPI notifications are similar for all SCPI instruments. Detailed information and an
overview of all notifications as defined in SCPI standard can be found in the corre-
sponding documentation.
SCPI notifications have negative codes (numbers). The error text being entered into
the error/event queue or being displayed is printed in bold face on the left together with
the error code. Below the error text, there is an explanation to the respective error.
13.3 Device-specific notifications
The following table contains all error messages specific for the instrument in alphabeti-
cal order and an explanation of the error situation. The positive error codes mark the
errors specific to the instrument.
The device-specific error messages set bit 3 in the ESR register.
The index provides a list of the error messages sorted according to their error codes.
Device-specific notifications
To Next Page
Loading...
