Rohde & Schwarz SMB100A - Page 199

Instrument Function
R&S
®
SMB100A
183Operating Manual 1407.0806.32 ─ 13
Mode - Stereo Modulation
Selects the mode for the audio signal. If the internal LF generator is selected as audio
source, the signal is generated according to the selection here. For external signals, the
signal type has to be entered.
"Mono Left"
A mono signal containing the left channel is generated/fed in.
"Mono Right"
A mono signal containing the right channel is generated/fed in.
"Stereo R=L"
A stereo signal with right and left channel is generated/fed in. The
channels have the same frequency and phase.
"Stereo R=-L"
The signal on the left external audio input is used for both channels, left
and right. The right channel is inverted.
"Stereo R!=L"
(External source only)
A stereo signal containing different, independent right and left channels
is fed in. It is possible, for example, to feed a fixed audio frequency to
the first channel while a frequency sweep is being performed in the
second channel.
Remote command:
[:SOURce]:STEReo:AUDio:MODE on page 370
LF Gen Freq - Stereo Modulation
(Audio source "LF Gen" only)
Sets the frequency of the LF generator signal.
This setting affects all analog modulations which use the LF generator as the internal
modulation source.
Remote command:
(two alias commands are available)
[:SOURce]:STEReo:AUDio[:FREQuency] on page 372
[:SOURce]:LFOutput<ch>:FREQuency on page 311
LF Gen Shape - Stereo Modulation
(Audio source "LF Gen" only)
Selects the shape of the LF generator signal.
This setting affects all analog modulations which use the LF generator as the internal
modulation source.
Remote command:
[:SOURce]:LFOutput:SHAPe on page 319
External R/L Impedance - Stereo Modulation
(External analog audio signal input only)
Selects the input impedance for the external analog audio signal inputs L and R.
Remote command:
[:SOURce]:STEReo:EXTernal:IMPedance on page 373
Modulation