Instrument Function
R&S
®
SMB100A
199Operating Manual 1407.0806.32 ─ 13
Calls the editor for editing the ontime/offtime values of the selected file. A file consists of
any number of ontime/offtime value pairs. The currently selected file is displayed.
"Ontime/us"
Sets the ontime of the ontime/offtime value pair.
Remote command:
[:SOURce<hw>]:PULM:TRAin:ONTime on page 356
"Offtime/us"
Sets the offtime of the ontime/offtime value pair.
Remote command:
[:SOURce<hw>]:PULM:TRAin:OFFTime on page 355
"Count"
Sets the number of repetitions for each ontime/offtime value pair.
Tip: If you set "Count = 0", the corresponding value pair is ignored in
the pulse sequence. With this function you can omit value pairs indi-
vidually, without deleting them from the table. To activate them again
set a value other than 0.
Remote command:
[:SOURce<hw>]:PULM:TRAin:REPetition on page 357
"Goto"
Selects row for editing.
If Goto row is selected, a window opens for entering the requested row.
(it is not possible to change individual positions of the list)
"Edit"
Calls a selection of possible actions described below.
"Insert Row"
Insert a new row before the marked row.
"Insert Range"
Insert new rows before the marked row. The number of rows to be
inserted can be defined in an entry window.
Modulation Generator and LF Output
To Next Page
Loading...
