Remote Control Commands
R&S
®
SMB100A
428Operating Manual 1407.0806.32 ─ 13
STEReo:DIRect "PTYN=<PTYN>"
STEReo:DIRect? "PTYN"
Sets or reads the RDS program type (PTY) name.
Setting parameters:
<PTYN> 8 ASCII characters
Note: An eight-digit value must always be set. Blank spaces, if
any, must also be entered, otherwise the value will not be accep-
ted.
Example:
STEReo:DIRect "PTYN=Football"
Sets the program type name to be transmitted to "Football".
STEReo:DIRect "GS=0A,10A”
Group 10A is activated in addition to group 0A. The program type
name "Football" is now transmitted.
Example:
STEReo:DIRect? "PTYN"
Response: "Football"
Example:
STEReo:DIRect "PTYN="
Transmission of PTYN in group 10A is stopped, even if group 10A
is contained in the group sequence.
STEReo:DIRect "RDS=<State>"
STEReo:DIRect? "RDS"
(for documentation reasons only)
Switches RDS on or off.
Use the SCPI command [:SOURce]:STEReo:RDS:STATe instead.
Setting parameters:
<State> 0 | 1
Example:
STEReo:DIRect "RDS=1"
RDS is switched on.
Example:
STEReo:DIRect? "RDS"
Response: "1"
STEReo:DIRect "RDS-PH=<Phase>"
STEReo:DIRect? "PDS-PH"
Sets the RDS phase.
Setting parameters:
<Phase> Range: 000 to 359 (ASCII coded decimal numbers)
Example:
STEReo:DIRect "RDS-PH=100"
The RDS phase is set to 100.
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5
To Next Page
Loading...
